-
This is the 3 legged oil filter wrench. I was trying to take the oil filter off during an oil change and it was on there good and tight. I used some oil filter pliers but they only crushed the filter and would not budge it. I tried putting a screwdriver through the filter but this only tore it a...Read more »
-
Video tutorial on how to cut a single ear or double ear crimp style hose clamp. I do show a couple different methods in this tutorial, each method will be dependant if you have the tools on hand. If you plan on using the high speed rotary tool method, DO NOT USE it on flammable fluids, this does...Read more »
-
I purchased these two pliers https://www.wire-sculpture.com/jewelry-pliers/90_Degree_Bent_Nose_Pliers-3392-94.html https://www.wire-sculpture.com/wubbers/Classic_Wubbers_Bent_Nose_Pliers-15576-1336.html Read more »
-
These are some of the tools that I use to cut sheet metal. These are all affordable and versatile. For the home shop any one of these would be sufficient for cutting sheet metal. The one exception is the floor shear. For more involved sheet metal projects some will work better than others. Read more »
-
Where to find https://www.amazon.com/dp/B00004SBB9/?tag=ckupa-20 IRWIN VISE-GRIP Original Locking C-Clamp with Swivel Pads, 11″, 20 for cheap. Read more »
-
BUY Here: https://www.eastwood.com/channellock-reg-87-7in-rescue-tool.html It’s a pry bar, it’s a spanner wrench, it’s a cable cutter- it’s your best friend in a worst case scenario. With the CHANNELLOCK® 87 Rescue Tool, you’ll: Cut through standard battery cables ...Read more »
-
As per requested..This video shows you how to remove locking skewers when you lost the key.. Shown in this video are “Pinhead” locking skewer set with the newer design that comes with special washers to prevent you from using a “Gator Grip” or similar socket design to rem...Read more »
-
KNIPEX’s Raptor Pliers – Pliers Meets Wrench. Read more »
-
I had a hard time changing the fuel filter on my Girlfriend’s 1999 Ford Ranger 4×4 Flexfuel. Spent 2 days figuring it out, and I hope this video saves someone time lol. (HERE IS HOW I DID IT:) You have to buy a ford fuel line quick disconnect tool ~5/16 ($3-10). Next place vice grip...Read more »
-
CV Joint Banding Tool Read more »
-
Buy the new Washer Clutch Assembly 285785 https://www.appliancepartspros.com/whirlpool-clutch-assembly-285785-ap3094537.html Follow these simple step-by-step instructions to replace the Washer Clutch Assembly on top load direct drive Whirlpool, Kenmore, Sears, Roper, KitchenAid, Inglis, Estate,...Read more »
