This is part 2 of my how to series on building a handbrake for the Thrustmaster TX on consoles, Xbox one, and PS4/PS3. this video covers how to wire/set up the base.
Tools/supplies needed for this complete series:
-Philips screwdriver
-Soldering pen
-Flux core solder
-Flux
-Wire strippers/crimpers
-Small pliers
-2.5 metric Allen wrench
-4 to 6 wire connectors
-1/4″ Heat shrink tube, at least 5ft or Electrical tape
-2 pin LED jump plug connector or a 2 pin connector of your choice
-Heat gun/hair dryer, or some other sorce or heat to shrink the heat shrink tubing, if not using shrink tubing don’t worry about it.
-10ft of awg 22 or 24 speaker wire i used 22.
-Small momentary button
-3/4″ long x 4 rc servo horn screws (not sure on the size)needs to be the same as the screw you pull out of the wheels connector
-Cheap hydraulic hand brake
-The rest will be gone over in the videos.
HANDBRAKE- https://amzn.to/2tmhy0e
SHRINK TUBING- https://amzn.to/2tm3HXV
MOMENTARY BUTTON- https://amzn.to/2tVfd9E
CONNECTOR- https://amzn.to/2tmcwB8
SOLDERING KIT- https://amzn.to/2tVdIbA
WIRE STRIPPERS/CRIPMS- https://amzn.to/2sjYcUT
WIRING SERVICES-
If you would like me to do this for you, contact me at the e-mail below and we can go over the details.
CONTACT E-MAIL- Jesse0357.js@gmail.com
Post time: Jul-02-2017