Make the mini tin can amp (Post-Apocalyptic Amplifier) with a few salvaged parts!
Become my patron on Patreon and help me shape the future of this channel!
https://www.patreon.com/evankale
facebook | https://facebook.com/evankale91
instagram | https://instagram.com/evankale91
twitter | https://twitter.com/evankale91
MATERIALS:
Tin can: https://amzn.to/2dqEcLB
LM386 chip: https://amzn.to/2dqegR6
Electrolytic Caps Pack: https://amzn.to/2dHfr0F
Ceramic cap pack: https://amzn.to/2dHprqI
Resistor pack: https://amzn.to/2d8uQaw
9v battery clip: https://amzn.to/2dYOzbh
DC Jack: https://amzn.to/2dt7hWc
SPDT Slide switch: https://amzn.to/2dYOF2D
Latching push button: https://amzn.to/2dHoz5p
Mono panel jacks: https://amzn.to/2dPR3Ws
20k ohm log taper potentiometer: https://amzn.to/2dqFp5q
Perfboard: https://amzn.to/2cQcN7q
SOLDERING GEAR:
Weller WES51 Analog Soldering Station: https://amzn.to/2dq7Q4m
MG Chemicals Silver Solder: https://amzn.to/2dHj0nq
Helping hand: https://amzn.to/2dc553O
TEST GEAR:
Multimeter: https://amzn.to/2dc54N6
Breadboard & Jumpers: https://amzn.to/2dHknm2
INSTRUCTABLE:
https://www.instructables.com/id/Post-Apocalyptic-Amplifier/
LM386 Datasheet:
https://www.ti.com/lit/ds/symlink/lm386.pdf
Post time: Jun-26-2017