This is a step by step instructional video on how to replace the rear brake pads & rotor on a SN95 (’94 – ’98) and New Edge (’99 – ’04) Ford Mustang with basic hand tools. It may also apply to other Ford models that use screw/twist in style rear brake calipers.
I show many tips & tricks to make this job quick, easy & painless. Including (but not limited to) the factory torque specs, methods to diagnose uneven pad wear and replacement part numbers for commonly damaged/missing/broken parts. I also show two different methods to compress the rear caliper piston, which is a screw in/twist in style caliper. It should take you about a half hour to an hour per side if you take your time.
Rear Brake Caliper Pin & Bolt Kit: DORMAN Part # HW14082
Rear Disc Brake Hardware Kit: DORMAN Part # HW5618
Rear Caliper Repair Kit: DORMAN Part # D352823
Disc Brake Tool Set: OEM Part # 27111
3/8″ Drive Disc Brake Piston Cube: OTC Part # 4589
My “’98 Ford Mustang 3.8L Repair & Maintenance” Playlist:
https://www.youtube.com/playlist?list=PLRaskbwUWbopRr2kgSkqn6EZfF41QADTj
The information in this video is for educational purposes only. Pet Rock assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use the information in this video at your own risk. Pet Rock recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Pet Rock.
Post time: Jun-19-2017