Get more info on Amazon-US: https://bit.ly/252Q2P5
This seat definitely does the job. Although it was a bit of a pain to get the perfectly straight. It would’ve been less confusing if it have came with some directions. I wasn’t able to the to sit while also tight in the stabilizer threads. I spent about an hour figuring it So here, I’ll post directions.
1. the halfway into your until have the inserts for at the top aligned. only want it so button doesn’t touch fingers holding bow.
2. There should be two nuts on the Separate them and loosely tighten one towards the Once again, the second the be a cm gap between the nuts.
3. Take wrenches or vice grips or of each, whatever works. And the in opposite at the same time keeping This will allow to a really snug fit.
4. Place the Hand the threaded rings up to the Make sure is nice and Grab and crank the in as far as they will go.
5. For extra sturdiness I then took my and bent the front around the The still slides fine with a small of force… Much better than having a moving around.
All in this is a great price Just buy a pole tip to the of the and you’ll be set! Looks absolutely fabulous on my Sucker Punch. I highly recommend this setup over the AMS Retriever if you’re an experienced bowfisher. Its is much faster… And cheaper, can’t beat that!
Good luck and shoot
Post time: Jun-13-2017