OEM manufacturer custom Various kinds of Industrial Brushes for Denmark Factory

An easy to follow tutorial on how to double the range of the excellent, very popular MJX X600 HexCopter: https://tinyurl.com/j8rp5mb Get at the guts of the hex and the controller and double the range for more than 500+ feet of flight. Follow along to see how it’s all done.

If you need X600 Spare parts: https://tinyurl.com/hdocbgo

Here’s my initial complete review of the MJX X600:

Here is a similar antenna to what I used to extend to top of controller https://www.ebay.com/itm/Antenna-2-4GHz-2dBi-Omni-WIFI-Wireless-Built-in-Bare-core-Aerial-RG178-7-cable-/271253910264?hash=item3f27fe32f8

-~-~~-~~~-~~-~-
I’m giving away drones here!

-~-~~-~~~-~~-~-

We are going to service rock shock reverb seat post. The problem is that my reverb developed a play. I will try to fix this with the service.

If your saddle moves back and forth as you can see here you will need to replace the top cap. It’s available as a preassembled part only.

For the service I will use original service kit. First we need to extract the seat post then remove the saddle. With the lock ring pliers remove the snap ring at the bottom. We push out outer seal head clean it and release the air. Now we need to remove the bottom cap. Be careful not to damage the stem, do not over tight the vice. Use the adjustable wrench to untighten the seal head. You can continue removing the head by hand. Use the pick tool to remove the o-ring from the lower tube. Now secure the lower tube into the vice and remove the top cap with the 34 mm wrench.

Pull out the upper tube and remove the brass keys, later use new keys with same number of stripes. Now remove the external bushing and the o- ring from the inner seal head.
Pull of the top cap. If you are using the 420 mm seat post pull out the plastic bottom insert and remove the o-ring.

From the top cap remove the dust wiper o-ring and foam ring. Replace the foam ring and o-ring with the new one. Sink the foam into the 2,5w suspension fluid.
Insert soaked foam ring into top cap. Now remove the energizer ring from the dust wiper and put the dust wiper into lower tube. Now push the dust wiper into top cap and reinstall the energizer ring.

Lubricate the o-ring and insert it back into the top cap.
Lubricate the inside of the top cap from both sides.
Put it back to upper tube.
Take the new upper seal head kit. Lubricate o-ring and place it back to the position on the inner seal head. Install new external bushing. Take new keys with same number of stripes. Lubricate the slots and install the keys.
Lubricate the inside of lover tube. Push the upper tube into the lower tube. You need to squeeze the external bushing. Rotate the upper tube to align the keys with key slots in the lower tube and push in the upper tube.

Important!!! To eliminate back and forth play install the new top cap else
reinstall and tighten the top cap with the 34 mm wrench.

Apply small amount of grease on the o-ring and reinstall it on the plastic bottom insert. Put new oring into the lower tube and insert plastic bottom insert and install new felt washer.
Lubricate and replace the orings on the outer seal head.
Thread and tighten the outer seal head.
Apply some more grease.
Pull in the outer seal head and reinstall the snap ring.
With the shock pump Inflate the seat post to 17 bar or 250 psi.
Replace the o-ring of the valve cap and install the valve cap.