Excellent quality for 5″ Backhand Round-Jaw Locking Pliers Azerbaijan Factories

Silk Natural’s Instructions:
Pressing SN Loose Eye Shadows with Great Impressions Pressing Medium
Materials: One pressing kit
a pair of pliers- regular slip joint pliers are fine, but longer nose Channel Lock pliers are preferable. Vice
grips or a c-clamp will also work. a 25 millimeter coin, or pressing disk, paper towels, a mixing bowl- a small measuring cup, or 30 gram jar is fine
a permanent marker for labeling the bottom of your eye shadow
1) Protect your work surface- this does get messy. It washes off pretty easily, but
you may want to wear gloves.
2) Place the eye shadow in the mixing bowl and add 5-6 pumps of Great
Impressions. The goal is to add just enough to get all of the powder to stick
together, but not so much that it’s mushy. It’s really similar to making pie crust if
you’re an experienced baker.
Mattes need 5-6 pumps. Shimmers will need slightly more. It’s VERY important
to use as few pumps as possible for matte colors otherwise they shrink too much
while they dry, and will separate from the pan. Most mattes can be pressed with 6
pumps- Fern, and Raven needed 7-8.
Shimmers generally need 8-9 pumps (for Frenchie start with 7).
Start with fewer pumps
than you think you’ll need. You can always add more if it’s too crumbly, but it’s
very difficult to get a good press if it’s too mushy.
3) Stir, and knead the mixture until everything comes together as a lump. Mattes
will look very powdery for a while, but they will come together. Keep stirring.
4) Place the mixture in the pan, and level it as best as you can.
5) Cover it with a paper towel, add the pressing disk on top and apply firm, even
pressure for 10 seconds.
6) Using the pliers repeat this process 2-3 more times using a dry spot on the
paper towel until there is no excess moisture. The firmer the press the more
durable the finished product will be. They break very easily if there is excess
liquid left behind. You can’t over press them.
If you’re getting marks from the pliers on the back of the pan you can use the pod
to protect the bottom. Just place the pan in the pod, and continue pressing.
7) Write the name, and date on the eye shadow with a permanent marker, and set
it aside to dry for 12-24 hours. Do not heat them- you’ll boil the alcohol and
create air bubbles, or melt the magnesium stearate, and turn it into an unusable
lump. Yes, it’s torture waiting for them to dry.
Troubleshooting:
If you’ve added too much pressing medium just gently blot the surface several
times until it’s not mushy, and then press very gently and slowly.
If one breaks you can re-press it by wetting it with a little rubbing alcohol, and
pressing it back in the pan.
Colors with more
silica- i.e. the Eyelights will need 10-12 pumps or more. Shelf life- Pressed eye shadows have an approximate shelf life of 2 years because of the propanediol in the
mixture.
They’ll probably be ok after 2 years, but we don’t know. Please write the date on your pressed shadows for
maximum safety.
The pans will rust if exposed to water for a long time. They are fine in the pressing process, but if they sit in
water for a while they will rust.
You can sanitize the pans with rubbing alcohol prior to pressing, but make sure they’re very dry before
adding the eye shadow.
It’s not really a necessary step because they’ll be in contact with alcohol for several hours, and that should be
sufficient.
Don’t dip a wet brush into your pressed shadows. To use them as a wet liner scrape up a little pile of powder,
then use a damp brush to pick up the powder.
Durability- the pressed shadows survive a standard drop test i.e dropping it onto concrete from 12 inches.
These are more fragile than a traditional pressed product, but should withstand carrying them around in your
purse.
You might want to carry a pod with your colors just in case one breaks.
Some pigments may become less intense. Carmine, and dyes do seep out during the pressing process. SN
doesn’t use dyes in their eye shadows, but other manufacturers might. Of the SN line Breathe was the only
one we felt lost a lot of vibrancy during the process. Red iron oxide also seems to bleed, but doesn’t
generally create a noticible change.
Wear time should be about the same. The colors may change slightly, but by the time you put it on your eye
over a primer you probably won’t notice much of a difference.
We have tested these with ALL of the current SN eye shadows, but we don’t know how shadows from other
manufacturers will work. It should be fine, but we don’t know. Press at your own risk.

Disclaimer: These products were sent to me. I am not sponsored and all opinions are honest and my own.

Ridgid 97787 Close Quarters Quick-Feed Cutter – Pipe Cutters – Amazon.com: https://amzn.to/1irDkUO

Turbotorch TX-504 Mapp/Propane Self-Lighting Extreme Hand Torch – Amazon.com: https://amzn.to/1d1E7XH

Amazon.com: Oatey 31320 180-Grit Open Mesh: Home Improvement: https://amzn.to/1f5f2K3

Amazon.com: Watts 3/4 LFFBV-3C Low-Lead Full Port 3/4-Inch Female Pipe Ball Valve, Brass, 2-Piece: https://amzn.to/1nukIW6

Amazon.com: Apollo 77CLF-240 Series Bronze Ball Valve with Stainless Steel 316 Ball and Stem, Two Piece, Inline, Lever, Solder End: https://amzn.to/RTmEL6

Oatey 30013 No. 5 Flux, 4-Ounce – Flux Paste – Amazon.com: https://amzn.to/1nACo29

Oatey 29024 Safe Flo 0.117-Inch ga. Bulk, Silver, 1/2 lb. – Stranded Wire – Amazon.com: https://amzn.to/QSO8Q9

Amazon.com: Park Supply of America 331755 Rolled Solder: Home Improvement: https://amzn.to/1lhnfmJ

Rectorseal 74026 3-Ounce C-Flux – Amazon.com: https://amzn.to/1hXXeXD

Amazon.com: 4-in-1 brush: Home Improvement: https://amzn.to/1gS3Fcp

Irwin Industrial Tools 2078110 10-Inch GrooveLock Pliers – Amazon.com: https://amzn.to/1cHdREx

Black & Decker The Complete Guide to Plumbing, Updated: Faucets & Fixtures – PEX – Tubs & Toilets – Water Heaters – Troubleshooting & Repair: Amazon.com: https://amzn.to/1M1G9Wo

(newest version) Milwaukee 2897-22 M18 18-Volt Lithium-Ion Cordless Brushless Hammer Drill/Impact Driver Combo Kit (Latest Model): Amazon.com: https://amzn.to/1RLjs0d

(newest version) DEWALT DCK287D2 20V MAX XR Li-Ion 2.0Ah Brushless Compact Hammer drill and Impact Driver Combo Kit: Amazon.com: https://amzn.to/22SnWFQ

To make this video I used the AmazonBasics 60-Inch Lightweight Tripod with Bag: Camera & Photo: https://amzn.to/15dgecs

Explore similar items: Amazon.com: AmazonBasics 60-Inch Lightweight Tripod with Bag: https://amzn.to/19QJueQ

The software used to edit and produce this video is Cyberlink PowerDirector 13 Ultra: Amazon.com: https://amzn.to/13TMGDB

Explore similar items: Amazon.com: CyberLink PowerDirector 13 Ultra [Download]: https://amzn.to/1CVV67u

The video was taken with the: Canon VIXIA HF R50 camcorder with 57X zoom Amazon.com: https://amzn.to/1tK4qtk

Explore similar items: Amazon.com: Canon VIXIA HF R50HD Camcorder with Wi-Fi and 3-Inch LCD (Black): https://amzn.to/1DEi3l2

This video was made using the: Transcend 64GB Class 10 SDXC Flash Memory Card (TS64GSDXC10E): https://amzn.to/1w02Oxn

Explore similar items: Amazon.com: Transcend 64GB Class 10 SDXC Flash Memory Card (TS64GSDXC10E): https://amzn.to/1LnxFIN

Amazon.com Gift Cards – In a Greeting Card – Free One-Day Shipping https://amzn.to/1qMbKkI

Amazon Student: Free Two-Day Shipping for six months, discounted Prime, and other exclusive deals for college students: https://amzn.to/1k42nJS

Free 30 day trial of Amazon Prime (free 2 day shipping, free movies and TV shows, and borrow books from Kindle library for free): https://www.amazon.com/gp/prime/signup/videos?tag=itsavidonyout-20

Bill and https://sparkychannel.com are participants in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com