12 Years Factory wholesale 4-PCS Anti-static Tweezer Sets Honduras Factory

https://www.marveltools.com.au/

https://www.marveltools.com.au/cutters/high-leverage-cutting-nippers.html

Marvel – MA730 High Leverage Cutting Nippers

- High leverage design with bevelled blades.
- For heavy duty cutting of steel wire.
- Made from drop forged chrome vanadium steel.
- Fully heat treated, black finish with polished jaws.
- Ground head with dipped vinyl handle grips.

•Length: 200mm
•Weight: 320g
•Grip: Dipped Vinyl
•Head: Drop-Forged Carbon Steel
Cutting Capacity: •Up to 2.0mm² diameter x 3 wires flat cable
•Up to 3.0mm² Copper Wire
•Up to 2.6mm² Steel Wire

I started this 4y 2.2 litre Hilux engine on the garage floor using a Ke70 4k toyota starter motor clamped on with vice grip c clamps.

These engines also came in 80s to 90s Hiace vans and other early 80s rear wheel drive toyota’s.

I also used the ignition system off my Lada Niva to start even left the coil connected to the lada and used the lada key to turn ignition on and off. I used a Victa 160cc 2 stroke petrol tank to feed the fuel.

I sat engine on a few retaining wall bricks and a block of wood to level and hold it up off the floor. I touched two wires together to trigger the starter motor.

I used some aerofast tie downs to hold the engine from moving around the floor.

I used jumper leads off both the Hilux and the Lada to provide the power.

I did a compression test afterwards and was between 125 to 135 PSI per cylinder.

The corolla 4k starter did not fit very well and I clamped it on with vice grips and used an adjustable spanner to hold the starter on an angle to engage with fly wheel.

A good bit of Kiwi ingenuity